FAQ

No they are not toys and the head covers are designed for art only.

If supervised by an adult then yes, otherwise no.

There should be 1x Golf Head Cover, 1x Permanent Marker Pen and 1x Design Page.

The Luggs head cover is designed to suit the maximum size head used as part of the rules of golf, which is 460cc. The head will fit but if it slightly tight it will just need a gentle push and it will fit perfectly. It has to be a reasonably tight fit so that the headcover does not move around or fall off during a round of golf.

The best way to do this is to pull the head cover off using the leg of the figure and it will simply slip off. 

Unfortunately this could happen if the head cover is used in a manner that is not normally used for a round of golf. For example thrown/ dropped or in transition, car etc. This can be simply fixed by using a form of super glue.

There may be a few occasions where there is a small mark/stain on figures and this is simply through handling of the products in the factory when they are made. This can be simply be removed by using soap and water.

If this happens then the head cover could become quite soft and supple but will harden again once back to an acceptable temperature. 

Yes but again due to the cabin pressure this may cause the figure to misshapen. If this happens then simply use a hair dryer to heat up and re-shape back to it’s original condition.

This depends on what is used on the head cover. If a permanent marker or paint are used then normally the head cover can only be used once. But if you use a washable marker then you can design it as many times as you like. But please be aware that if you use a washable marker pen then if wet the design can be removed so it would not be ideal to be used on a golf course when raining etc.

If this happens then you will need to go over the design again to re-design in the same way as the original design.